TM 9-2320-280-34
Section II. ILLUSTRATED MANUFACTURING INSTRUCTIONS (Cont'd)
ASSEMBLY INSTRUCTIONS (Cont'd):
NOTE
All dimensions are in inches.
Remove all burrs and sharp edges after each fabrication.
Perform step 4 if rigging over head support sling for transmission use.
Perform step 5 if rigging over head support for engine use.
4.
Position L.H. and R. H. transmission bracket (1) to the ends of support chain (14) and install two bolts
(2), four washers (3), and two nuts (13).
5.
Position two engine brackets (15) to the ends of support chain (14) and install two bolts (2), four
washers (3), and two nuts (13).
6.
Install eye bolt (4) and eye bolt (6) in turn buckle (5).
NOTE
Perform steps 7 and 8 if rigging overhead support sling for
transmission use.
Perform steps 9 and 10 if rigging overhead support sling for
engine use.
7.
Position R.H. eye bolt (6) to hole (9) in overhead support sling (11) and install bolt (7), two washers (8),
and nuts (12). Do not tighten nuts (12) or use hole (10).
8.
Using Centerlink, install support chain (14) on L. H. eye bolt (4) with bolt (2), two washer (3), and nut
(13).
9.
Position R. H. eye bolt (6) to hole (10) in overhead support sling (11) and install nut (12). Do not tighten
nuts (12) or use hole (10).
10.
Using Center link, install support chain (14) on L.H. eye bolt (4) and install bolt (2), two washers (3),
and (13).
C-24
