TM 9-2320-280-34
22-10. AMBULANCE EXTERIOR BODY REPAIR (Cont'd)
o. Right Rear/Lower/Upper body Panel Repair
1.
Remove door weatherstrip (TM 9-2320-280-20).
2.
Scribe two lines (7) centered over twenty-one rivets (3) and (5) on rear lower/upper body panel (1). J
Extend scribed lines (7) a minimum of 1.00-in. (25.4 mm) onto body panels (4).
3.
Using a 0.125-in. (3.175 mm) drill, remove ten rivets (3) from rear lower/upper body panel (1) and
body panels (4).
4.
Using a 0.187-in. (4.75 mm) drill, remove eleven rivets (5) from rear lower/upper body panel (1) and
body panels (4).
5.
Remove rear lower/upper body panel (1).
6.
Remove adhesive residue and clean body panels (4). Do not remove scribed lines (7) marked in
step 2.
7.
Position rear lower/upper body panel (1) on body panels (4) and transfer scribed lines (7) marked in
step 2. Remove rear lower/upper body panel (1).
8.
Using scribed lines (7) marked in step 7, drill ten 0.125-in. (3.175 mm) diameter holes (9) in rear
lower/upper body panel (1).
9.
Using scribed lines (7) marked in step 7, drill eleven 0.187-in. diameter holes (8) in rear lower/upper
body panel (1).
10.
Apply approximately 0.125-in. (3.175 mm) thickness of adhesive sealant to rear lower/upper body
panel (1) and body panels (4).
11.
Install rear lower/upper body panel (1) on body panels (4) with ten rivets (2) and eleven rivets (6).
12.
Spot paint rear lower/upper body panel (1) and body panels (4) (TM 43-0139).
13.
Apply wicking sealant to eleven rivet heads (6) installed in step 11.
14.
Install door weatherstrip (TM 9-2320-280-20).
22-42
