TM 9-2320-280-34
6-3.1. 100 AMPERE ALTERNATOR (12340912) REPAIR (Cont'd)
11. Remove sealer from two brush holder terminal nuts (4).
NOTE
Prior to removal, tag leads for installation.
12. Remove two terminal nuts (4), lockwashers (5), and disconnect two leads (3) from two brush holder
terminals (6). Discard lockwashers (5).
13. Remove sealer from two brush holders (7). Remove two brush holders (7), brushes (9), and
preformed packings (8) from drive end housing (1). Discard preformed packings (8).
14. Using puller, push drive end of rotor shaft (10) out of drive end housing (1) and stator (2).
15. Remove sealer from three stator lead terminal screws (19). Remove three stator lead terminal
screws (19) from three stator leads (20), electrical connector lead (16), and three rectifier
mounts (18).
16. Scribe alignment marks (17) on drive end housing (1) and stator (2). Separate drive end housing (1)
and stator (2).
17. Remove two screws (13), lockwashers (12), and terminal cover (11) from drive end housing (1).
Discard lockwashers (12).
18. Remove two screws (14), lockwashers (15), and electrical connector (21) from drive end housing (1).
Discard lockwashers (15).
6-18.4
Change 2
