TM 9-2320-280-34
3-24. ENGINE REMOVAL (6.5 L) (Cont'd)
NOTE
Perform steps 64 through 78 for vehicles equipped with Neihoff
200 amp alternator only.
Prior to removal, tag leads for installation.
64.
Disconnect regulator plug (9) from voltage regulator (8).
65.
Slide back rubber boot (26) and remove nut (25), lead 5A (24), and washer (23) from red (energize)
terminal (22).
66.
Slide back rubber boot (1) and remove nut (2), lead 2A (3), and washer (4) from yellow (AC)
terminal (5).
67.
Slide back rubber boot (18) and remove nut (19), lead (17), and washer (20) from terminal (21).
68.
Remove two screws (16), spring tension washers (15), and washers (14) connecting voltage
regulator (8) to alternator (13). Discard spring tension washers (15).
69.
Remove nut (41), lockwasher (40), washer (39), and lead 3B (38) from negative stud (36). Discard
lockwasher (40).
70.
Disconnect lead (12) from connector (11).
71.
Slide back rubber boot (42) and remove nut (27), lockwasher (28), washer (29), fuse link (30),
insulator washer (43), alternator positive cable (31), and washer (32) from positive stud (33).
Discard lockwasher (28).
72.
Remove drivebelt (34) from alternator pulley (35).
73.
Loosen thru-bolt (46) securing alternator (13) to alternator mounting bracket (37) and support
bracket (48).
74.
Remove capscrew (6), lockwasher (7), spacer (10), and voltage regulator (8) from alternator (13).
Discard lockwasher (7).
75.
Deleted
76.
Deleted
WARNING
Alternator must be supported during removal and installation.
Failure to support alternator may cause injury to personnel or
damage to equipment.
77.
Remove nut (44), lockwasher (50), washer (45), thru-bolt (46), washer (45), and spacer (49) from
alternator (13), power steering lines bracket (47), support bracket (48), and mounting bracket (37).
Discard lockwasher (50).
78.
Remove alternator (13) from mounting bracket (37).
3-128
Change 2
