TM 11-7440-284-14
4-50. INSTALLING ANTENNA CABLING.
This task covers:
Installation
INITIAL SETUP
Tools
Personnel Required
Electric drill
One mechanic
3/32-inch drill bit
Cutting pliers
Equipment Condition
Flat-tip screwdriver
Antenna mounting bases installed.
Materials/Parts
Control cable (3 required)
RF cable (3 required)
Cable clamp kit
ACTION
ITEM
REMARKS
LOCATION
NOTE
Cable clamps must be cut into desired lengths, using cutting
pliers before installing.
1. Front roadside
RF cable (1) and
Route.
mounting base
control cable (2)
Routing must be done close to the
underside of carrier bed side wall
top rail.
2.
Carrier walls (3)
Using electric drill and 3/32-inch drill bit,
drill.
Drill every two to three feet
following cables.
RF cable (1),
Using flat-tip screwdriver, install.
3.
control cable
(2), cable clamp
(4) and screw (5)
NOTE
See SB 11-131 for antenna cabling hook-ups.
4-100
