TM 11-7440=284-14
4-9. REAR ANTENNA BRACKET MOUNTING HOLES.
This task covers:
Preparation for drilling
INITIAL SETUP
Personnel Required
Tools
One mechanic
Felt-tip pen
Tape measure
Equipment Condition
Cross-tip screwdriver
Truck set at installation site.
Materials/Parts
None
ACTION
REMARKS
ITEM
LOCATION
Using cross-tip screwdriver, remove.
Screw (1) and
Outside corner
1.
There are two screws. Step 1 is
rear curbside wall
Iockwasher (2)
typical for both screws.
Do step 1 again.
2.
Screw (3)
Remove.
Reflector (4)
3.
Save.
Measure 16 5/16 inches from lower edge of
Mark (5)
4.
carrier body. Measure 1 1/8 inches in from
outside edge of body. Using felt-tip pen,
mark.
Measure 3 1/2 inches over from mark (5). Using
5.
Mark (6)
felt-tip pen, mark.
Measure 3 inches up from mark (6). Using felt-
Mark (7)
6.
tip pen, mark.
Measure 3 1/2 inches over from mark (7). Using
Mark (8)
7.
felt-tip pen, mark.
Measure 3 11/16 inches up from mark (8). Using
Mark (9)
8.
felt-tip pen, mark.
Measure 3 1/2 inches over from mark (9). Using
Mark (10)
9.
feit-tip pen, mark.
4-12
