TM 9-2320-289-34
6-6.
FRONT AXLE DIFFERENTIAL REPAIR (M1009) (Con’t).
NOTE
Ensure that pinion gears (7), side gears (8), and thrust washers (9) are
marked for assembly,
5.
Rotate 2 side gears (8). Remove 2
pinion gears (7) and thrust washers
(9). Remove 2 side gears and thrust
washers,
b. CLEANING AND INSPECTION
WARNING
l Dry cleaning solvent P-D-680 is toxic and flammable. Always wear
protective goggles and gloves and use only in a well-ventilated area.
Avoid contact with skin, eyes, and clothes and DO NOT breathe vapors.
DO NOT use near open flame or excessive heat. The solvent’s flash
point is 100°F-138°F (38°C-59°C). If you become dizzy while using
cleaning solvent, immediately get fresh air and medical help, if solvent
contacts eyes, immediately wash your eyes with water and get medical
aid.
l Compressed air used for cleaning purposes should never exceed 30 psi
(207 kPa). Us. only l ffective chip guarding and personnel protective
equipment (goggles/shield, gloves, etc.). Failure to follow this warning
may result in serious injury to personnel.
1.
Clean all removed components with dry cleaning solvent and dry with compressed air.
2.
Clean and inspect differential side bearings in accordance with TM 9-214. If one side bearing is
damaged, replace both side bearings.
TA50624
6-26
