c. lNSTALLATION

b. CLEANING AND INSPECTION - TM-9-2320-289-34_569

Table 6-1. Determining Side Bearing Shim Requirements

/.25ton/TM-9-2320-289-34 CUCV Series Trucks at intermediate direct support and general support level Manual
Page Navigation
553

TM 9-2320-289-34 6-5. FRONT AND REAR AXLE DIFFERENTIAL REPLACEMENT (M1009) (Con’t). c. lNSTALLATION 1. If removed, install 2 new axle shaft inner seals in housing side bores, 2. Install 2 bearing cups (6) as tagged, over side bearings (10), Install differential case (7) assembly inside housing. 3. Install bearing strap tool (8) over left side bearing cup (6) with 2 bolts. 4. With ring gear (12) tight against drive pinion (9), insert bearing preload gage (13) between left bearing cup (6) and housing. 5. While moving bearing preload gage (13), turn adjusting nut clockwise until a noticeable drag is felt. Tighten Iockbolt on side of tool, 6. Between right bearing cup (6) and housing, install spacer if removed, and a shim (5) thinner than what was originally installed. Install a feeler gage (11) between shim and housing. Feeler gage must be of sufficient thickness to produce a slight drag when moved between shim and housing, TA50517 6-18

Privacy Statement
Press Release
Contact