3-7.1. ENGINE OIL PAN REPLACEMENT.

3-7. VACUUM PUMP REPLACEMENT.

3-7.1. ENGINE OIL PAN REPLACEMENT (Cont)

/.25ton/TM-9-2320-289-20 CUCV Series Trucks at Unit level Manual
Page Navigation
119

TM 9-2320-289-20 3-7.1. ENGINE OIL PAN REPLACEMENT. This task covers: a. Removal c. Installation b. Cleaning and Inspection INITIAL SETUP: Equipment Condition Materials/Parts Front of truck raised and supported by jack stands with front axle hanging free. Starter removed. (See paragraph 4-5) Engine oil level indicator tube and seal removed. (See paragraph 3-3) Engine oil drained. (See paragraph 3-4) Engine oil filter removed. (See paragraph 3-4) One engine oil pan gasket One engine oil pan seal Dry cleaning solvent (Item 15, Appendix C) RTV sealant (Item 41, Appendix C) General Safety Instructions Dry cleaning solvent is flammable and must not be used near open flame. Use only in a well-ventilated area. NOTE Step 1 only applies to trucks equipped with winterization kits. 1. Loosen clamp (4) and disconnect front exhaust pipe (3) from engine oil pan (5). Remove 4 screws (1) and heat exchange pipe (2). TA701823 Change 2 3-12.1

Privacy Statement
Press Release
Contact