TM 11-7440-284-14
4-40. INSTALLING SLEDGE HAMMER AND MOUNTING BRACKETS.
This task covers:
Installation
INITIAL SETUP
Tools
Materials/Parts (Cont)
Spring clip
7/16-inch box end wrench
Sledge hammer
Materials/Parts
Personnel Required
1/4-20 x 1 3/4 inch long hex
One mechanic
head screw (3 required)
1/4-inch flat washer
14-inch split Iockwasher
Equipment Condition
Spacer, SC-B-866250
Submount installed.
Spacer, SC-B-866251
Sledge hammer bracket
ACTION
REMARKS
ITEM
LOCATION
Place and aline holes.
Bracket (1),
1. Submount, roadside
spacer (2) and
submount (3)
Using 7/16-inch box wrench, install.
Screw (4), lock-
2.
There are two screws. Step 2 is
washer (5) and
typical for both screws.
flat washer (6)
Do step 2 again.
Screw hole (7)
3.
Place and aline holes.
Spring clip (8),
4.
spacer (9) and
submount (3)
Using 7/16-inch box wrench, install.
Screw (10), lock-
5.
washer (11) and
flat washer (12)
Install.
Sledge hammer (13)
6. Submount, roadside
7.
Install.
Sledge hammer
bracket cover (14)
and wingnut (15)
8.
Install.
Wingnut (16)
4-82
