(6) If removed, install driver's side front door.
WEIGHT AND BALANCE DATA.
Weight and balance are not significantly affected by this MWO.
QUALITY ASSURANCE REQUIREMENTS.
The installer is responsible for the following instructions in MWO 9-2320-280-20-4. The installer will report
modification kits received that are damaged or have missing component parts, so the supplier can be properly notified.
The installer is responsible for functional testing of installed modification kit. Any discrepancies noted will be corrected
before the vehicle leaves the installer's work area.
RECORDING AND REPORTING OF THE MODIFICATION.
a. Records and reports. (Refer to DA PAM 738-750.)
b. Marking Equipment.
(1) After Steering Column Bracket Modification Kit is installed, mark MWO number "9-2320-280-20-4" in the
MWO Applied Block and date applied in Date Block on MWO Instruction Plate 10930014.
Do not remove any existing MWO Instruction Plates affixed to the reinforcement panel.
(2) Install 10930014 MWO instruction plate by drilling a 0.104-inch diameter hole within designated area on
body reinforcement panel and secure with MS21318-20 drive screw as shown in figure 4.
(3) After drive screw is installed, flatten or remove any protruding drive screw material from inside of body
c. Identification Data.
MATERIAL CHANGE (MC) NUMBER.
The MWO is authorized by Material Change (MC) number 1-93-06-4456.
a. When installed correctly, the steering column brackets will appear as shown in figure 5.
b. After the steering column brackets are installed, the steering column should be tested for secure mounting. Any
faults detected or discrepancies noted will be corrected before the vehicle is returned to normal service.