TRANSFER CASE MAINTENANCE (M1028A1 AND M1031 ) (Cont).
Secure front output shaft yoke (50) in a suitable holding device and remove locknut (51), 1 flat
washer, and 1 seal washer. Remove front output shaft yoke, Discard locknut and seal washer.
Remove 4 bolts (82) and front output shaft retainer (83). Remove gasket and discard. Remove
seal (84) from front output shaft retainer and discard.
Remove 8 bolts (71) at rear retainer (72). Tap on front output shaft (88) with a soft-faced
hammer and remove rear retainer, front output shaft, and gear assembly, as a unit. Remove
gasket from rear face of transfer case (1) and discard.