TRANSMISSION CONTROL VALVE ASSEMBLY AND DETENT SOLENOID
Install open end of governor screen
assembly (8) into marked governor
feed pipe hole (9) in transmission
case. Install 2 governor pipes (5) into
holes in control valve assembly (3).
Position control valve assembly (3).
Check that governor pipes (5) are
properly fitted into transmission case
holes. Check manual valve (7) to
ensure that it is indexed with pin on
inside detent lever (1), Ensure that
gaskets and spacer plate (14) are not
It may be necessary to lightly tap
on governor pipes (5) to seat them
while starting control valve body
Loosely install 10 bolts (6) to secure
assembly (3) to
transmission case. Tighten all bolts to
10 Ib.-ft. (14 N.m).
Install detent roller and spring
assembly (2) with bolt (4). Tighten
bolt to 10 Ib.-ft. (14 N.m).
5 - 3 7