TM 9-2320-289-20
11-32. ROOF PANELS AND SUPPORTS REPLACEMENT (M1008 AND M1008A1).
This task covers:
a.
Removal
b. Installation
INITIAL SETUP:
Equipment Condition
Materials/Parts
Both battery negative cables disconnected.
Two locknuts
(See paragraph 4-38)
Cargo cover insulator removed (if removing
roof panels). (See paragraph 11 -27)
Personnel Required
MOS 63B (2)
NOTE
If removing supports (12 and 15), perform steps 1-5.
If removing roof panels (8), perform steps 1-9.
If removing roof bow support, perform steps 10-13.
Perform step 11 only if replacing right roof bow support.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Disconnect domelight wiring harness connector (16) at ceiling.
Remove domelight wiring harness clips (14) from front support (15).
Remove 4 nuts (17) and roof support bracket (18) with attached domelight.
Remove 2 nuts (7) and disengage slot in front support (15) from air inlet adapter
(6). Remove front support and air inlet assembly.
Disengage rear support (12) from panel assembly (10) and remove rear support.
Remove 6 nuts (11) at panel assembly (10).
At front of roof bow (1), remove 2 nuts (5), retaining straps (4), and bolts (2).
assembly
Remove roof support bracket (3), 2 roof support brackets (13), and 3 roof support brackets
(9) .
Remove 2 roof panels (8).
11-116