SERVICE AND TROUBLESHOOTING INSTRUCTIONS
Section l. REPAIR PARTS, SPECIALTOOLS, TEST, MEASUREMENT,AND
DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT EQUIPMENT
2-1. COMMON TOOLS AND EQUIPMENT
For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment
(MTOE) applicable to your unit.
2-2. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT
Special Tools, Test, Measurement, and Diagnostic Equipment (TMDE), and Support Equipment used to
maintain the vehicles covered in this manual can be found in TM 9-2320-289-20P.
2-3. REPAIR PARTS
Repair parts are listed and illustrated in TM 9-2320-289-20P.
Section Il. SERVICE UPON
a. Upon receipt of a new, used, or reconditioned vehicle, you must determine if the vehicle has been prop-
erly prepared for service. The following steps should be followed:
(1) Inspect all assemblies, subassemblies, and accessories to be sure they are in proper working or-
(2) Secure, clean, lubricate, or adjust as needed.
(3) Check all Basic Issue Items (TM 9-2320 -289-10) to be sure every item is present, in good condi-
tion, and properly mounted, or stowed.
(4) Follow general procedures for all services and inspections given in TM 9-2320-289-10.
The operator will assist when performing service upon receipt inspections.
See TM 9-2320-289-10 when checking equipment for proper operation.
Refer to TM 9-2320-289-10 for information concerning brake-in procedures.
2-5. GENERAL INSPECTION AND SERVICING INSTRUCTIONS
The following steps should be taken while performing general inspection and services:
(1) Use TM 9-2320-289-10 as well as other sections of this manual, when servicing and inspecting
Drycleaning solvent is flammable and will not be used near an open flame. A fire extinguisher
will be kept nearby when the solvent is used. Use only in well-ventilated places. Failure to do
this may result in injury to personnel and/or damage to equipment.
(2) Clean all exterior surfaces coated with rust-preventive compounds. Use drycleaning solvent (Ap-
pendix C, Item 15).