BRAKE PAD AND CALlPER REPLACEMENT (Cont).
All Except M1009
Spring (7) must be installed on top of key (5).
Use soft-faced hammer and punch to install key (5) and spring (7).
Position caliper (2) on bracket (4) and rotor (1). Install spring (7) and key (5) on bracket with
screw (6). Securely tighten screw.
Install bleeder valve (9) and dust cap (10) if removed.
One copper washer must be installed between
caliper flex hose and
Connect caliper flex hose to caliper (2) with bolt and 2 new copper washers.
Fill master cylinder to proper level. (See LO 9-2320-289-12)
Install front wheel. (See paragraph 8-2)
Pump brake pedal several times to adjust caliper, then check operation of brakes.
Bleed system if caliper was replaced. (See paragraph 7-6)