RADIATOR AND FAN SHROUD REPLACEMENT (Cont).
Remove terminal wire and low engine coolant sensor assembly (16).
Remove 4 bolts (12)
Remove 4 bolts (18)
Remove radiator (1)
from top and front of upper mounting panel (13).
and upper radiator mounting brackets (15 and 17) from frame.
and upper and lower radiator insulators (14).
CLEANING AND INSPECTION
Compressed air used for cleaning purposes should never exceed 30 psi
(207 kPa). Use only effective chip guarding and personnel protective
equipment (goggles/shield, gloves, etc.). Failure to follow this warning
may result in serious injury to personnel.
If inspecting fan shroud (2), perform step 3.
Use compressed air and water to remove dirt and debris embedded in radiator (1).