TM 9-2320-280-34
6-9. BODY WIRING HARNESS REPLACEMENT (Cont'd)
b. Installation
CAUTION
Use care when installing harness. Snagging or pulling may
damage harness.
NOTE
Refer to TM 9-2320-280-20 for repair of wiring harness
connectors.
1.
Position harness (5) in approximate mounting position. Feed forward branch of harness (5) through
hole (20).
2.
Install left body mounts (para. 13-3).
3.
Install grommet (19) over yellow locator tape (22) and position closeout plate (18) on grommet (19).
NOTE
The top screws connecting the closeout plate may be longer than
the rest, if the fuel filter drain tube is routed to the top of the
closeout plate.
4.
Install grommet (19) and closeout plate (18) on cowl (23) with four screws (24) and nuts (21).
5.
Install harness ground lead 57E (8) on heater motor (7) with washer (9) and screw (10).
6.
Connect harness lead 400D (6) to heater motor (7).
7.
Connect harness leads 27K (12), 57F (13), and 71C (11) to windshield wiper motor jumper harness (3).
8.
Install harness (5) on "A" beam (2) with two clamps (14), capscrews (1), and locknuts (4).
NOTE
Perform step 9 for M1097, A1 and A2 series, and M1123.
9.
Install screw (16) and transfer case indicator lamp ground lead (17) on cylinder head (15).
M1097, A1 AND A2 SERIES,
AND M1123
Change 2