Section I. REPAIR PARTS, SPECIAL TOOLS, TEST, MEASUREMENT
AND DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT EQUIPMENT
2-1. COMMON TOOLS AND EQUIPMENT
Refer to Modified Table of Organization and Equipment (MTOE) for authorized common tools and
equipment applicable to your unit.
2-2. SPECIAL TOOLS AND SUPPORT EQUIPMENT
Special tools and support equipment are listed and illustrated in TM 9-2320-280-24P.
2-3. TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE)
Calibrate all measuring and test equipment used to determine equipment conformance in accordance with
2-4. FABRICATED TOOLS
Fabricated tools needed to maintain the equipment in this manual can be found in appendix C. These tools
are not available for issue, but must be fabricated and applied by direct and general support personnel only.
2-5. REPAIR PARTS
Repair parts are listed and illustrated in TM 9-2320-280-24P, except for engine assembly repair parts which
are listed and illustrated in TM 9-2815-237-34P.
Pre-1990 and 1990 and above 6.2 L and 6.5 L engines have some new and revised parts which are not
interchangeable. These part changes affect some of the maintenance procedures in chapters 3 and 4. Refer
to engine decal on left rocker arm cover before performing maintenance procedures and ordering
The 6.2 L engine is identified by a decal which is adhered to the left rocker arm cover. The 6.5 L engine is
identified by a serial number bar code.